Orgapack's OR-T R19 Battery Powered Push Style Combination Tool

The ORT R19 is not available in the US, please see the BPT-L19.

The Orgapack OR-T R19 is a single reverse notch sealer used with regular duty or high tensile steel strapping, and recommended for use on round or irregular loads. Weighing 10 pounds (half a pound more than the pneumatic PNSC2), the ORT R19 tool uses its duck bill nose to push the seal, a feedwheel to pull tension, and jaws to notch the seal in a full combination action. The BPT-L19 applies up to 674 lbs. tension to steel strapping. The BPT-L19 is a relatively easy tool to operate thanks to the two bottom control system. The strap easily slides out after each strapping cycle. The touch screen allows you to change the tension settings, or to switch between manual and automatic.

The OR-T R19 is available in three sizes: 

OR-T R13: 1/2" (12.7mm) x 0.015-0.024" Seal .5 Inch Push Seal 

OR-T R16: 5/8" (15.9mm) x 0.015-0.024" Seal .625 Inch Push Seal 

OR-T R19: 3/4" (19.0mm) x 0.015-0.024" Seal .75 Inch Push Seal  

Orgpack OR-T R19 parts will soon be loaded onto the order parts tab of this page for replacement parts.

Versatility:

How to Strap with the OR-T R19: While operating any strapping tool, safety precautions must be taken. Safety goggles and hand protection must be used and careful distance from the tool and the cargo must be maintained. First, thread the strap through the seal and wrap the strap around the load. Remove excess slack and pull opposite end back through the seal over top of the original strap. Hold the OR-T R19 in right hand and the strap in the other. Use the lever to lift the foot and slide the strapping in. Slide the tool forward as far as possible to ensure tight tensioning. Press the button to start tensioning. Once desired level is reached, the tool will automatically shut off. Press the sealing button to compete the sealing function until the tool automatically stops the sealing process. 

For use with 1/2"-3/4" (16 mm-19 mm) x .015"-.024" Apex Plus or Magnus strapping 

Tension:  674 pounds

Joint type: Single reverse notch 

Weight: 10 lbs. (4.5 kg)

Allstrap Opinion:

The OR-T R19 tool is a great and easy option to replace your air or hand tools.  We love how well balanced this tool feels in your hands.  The PNSC2 is a good tool, but all of the weight is in front of your wrist.  The battery on the back of the OR-T R19 balances the jaw stack, making this tool easier to hold and use.  We like the automatic function on this tool, which means you hit button 1, and the tool will pull tension (up to the force you set), then automatically seal and cut.  Eliminating the second button push makes the OR-T R19 easier to use, and faster.  We have the BPT-L19 tool in the field, and it holds up very well.  The battery is protected, so even dropping it on the battery almost never causes damage.  You can expect the same parts to wear on this as on pneumatic tools, specifically the wheel.  We recommend buying the OR-T R19.